Qolsys IQ Panel 2 - Image Sensor IQ Card Installation
The guides attached to this page have been written by a third party and are not maintained by True Protection. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Incompatible Device trouble condition - Image Sensor
The Incompatible Device trouble condition appears when an Image Sensor is connected to a 2GIG Go!Control panel on an incompatible firmware version. 2GIG Go!Control 2 The trouble condition that appears reads, Your panel firmware does not support Image Sensor. Please upgrade to version 1.10 to enable functionality…
Improve Image Sensor signal strength with a 2GIG GoControl
2GIG Image Sensors do not show the signal strength due to the radio frequency (RF) protocol used by 2GIG. However, 2GIG panels can check if the Image Sensor is connected to the network through the native Sensor Test menu. To access Sensor Test from the panel: * Tap Security . * Tap Menu . * Enter the master o…
Improve Image Sensor signal strength with a 2GIG GC3
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the GC3 panel. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting signal strength a…
2GIG GC3 Image Sensor (2GIG-IMAGE2) - Installation Guide
Product overview The Image Sensor for 2GIG GC3 panels is a pet immune PIR (passive infrared) motion detector with a built-in camera. The sensor is designed to capture images during alarm or non-alarm events. Users can also initiate image capture on-demand to Peek-In on their property. Images are stored locally and …
Enroll an Image Sensor on a Qolsys IQ Panel 2
Requirements The following are required to enroll Image Sensors to a Qolsys IQ Panel 2: * The Qolsys Image Sensor daughter card must be installed. For more information about installing the Image Sensor daughter card on the Qolsys IQ Panel 2, see Qolsys IQ Panel 2 Image Sensor IQ Card Installation . * The custome…
2GIG GC3 Image Sensor (ADC-IS-300-LP) - Installation Guide
Product summary & technical specifications The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera designed to capture images during alarm or non-alarm events when motion is detected. Product features: * Communicates wirelessly to the security control panel * 35 foot de…
Qolsys IQ Panel 2 Image Sensor ADC-IS-300-LP - Installation Guide
Product summary and technical specifications The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera designed to capture images during alarm or non-alarm events when motion is detected. Product features: * Communicates wirelessly to the security control panel * 35 foot de…
