Improve Image Sensor signal strength with a 2GIG GoControl
2GIG Image Sensors do not show the signal strength due to the radio frequency (RF) protocol used by 2GIG. However, 2GIG panels can check if the Image Sensor is connected to the network through the native Sensor Test menu. To access Sensor Test from the panel: * Tap Security . * Tap Menu . * Enter the master o…
Improve Image Sensor signal strength with a 2GIG GC3
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the GC3 panel. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting signal strength a…
Improve Image Sensor signal strength with a Qolsys IQ Panel 2
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the Image Sensor daughterboard. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting …
