2GIG GoControl - Equipment Codes
Equipment Code Equipment Description Panel firmware version required 9999 Alarm.com Image Sensor Note : Must be added at the panel 1.10+ 1062 2GIG Tilt Sensor 1.19+ 1064 2GIG Bypass Sensor 1.14+ 1065 2GIG Flood Sensor 1.14+ 1066 2GIG Shock Sensor 1…
Clear a panel tamper on a 2GIG GC3
When a panel tamper occurs on a 2GIG GC3, it locally displays Console Tamper and the trouble condition appears on Alarm.com. The tamper switch on a 2GIG GC3 is the white plastic rectangle on the bottom of the panel near the 2GIG WLAN chip. How to resolve: * Affix the backplate onto the panel and verify the wh…
2GIG GoControl - Cellular Module Installation Guide
It is strongly suggested to perform the steps shown in this guide in your office or lab at least 24 hours before going to the installation site. This ensures that the SIM card will be ready to communicate with Alarm.com and also allow you to detect any possible problems before going to the client site. The advantage…
2GIG GC3 Image Sensor (ADC-IS-300-LP) - Installation Guide
Product summary & technical specifications The Image Sensor is a pet immune PIR (passive infrared) motion detector with a built-in camera designed to capture images during alarm or non-alarm events when motion is detected. Product features: * Communicates wirelessly to the security control panel * 35 foot de…
Disable trouble beeps on a 2GIG GC3
There is no way to indefinitely disable trouble beeps at all times for the 2GIG GC3 panel. Trouble beeps include beeps caused by AC power loss, system low battery, sensor low battery or RF supervision, failure to communicate with the Monitoring Station, control panel tampering while disarmed, and cell radio faults. …
Disable trouble beeps on a 2GIG GoControl
There is no way to indefinitely disable trouble beeps at all times for the 2GIG GoControl panel. Trouble beeps include beeps caused by AC power loss, system low battery, sensor low battery or RF supervision, failure to communicate with the Monitoring Station, control panel tampering while disarmed, and cell radio fau…
2GIG GC3 - Equipment Codes
Required for all wireless zones, keyfobs, and keypads. For information on the loop number to program, refer to the device's installation manual. Wireless Zones - Equipment Codes Equipment Code Description 0000 Other 0862 2GIG Thin D/W (Surface) Contact 0863 2GIG Recessed Door Contact 0869 2GIG PIR wi…
2GIG Doorbell (2GIG-DBELL1-345) - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG Doorb…
Change the language of a 2GIG GoControl
The language of a 2GIG GoControl is part of its firmware. An Over-The-Air (OTA) upgrade to a different language version can be sent using the Partner Portal or MobileTech app. Language firmware can also be applied locally at the panel using 2GIG's upgrade cable and a computer. For more information about local upgrad…
