The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
The firmware version of a 2GIG GoControl can be found in the panel. To find the firmware version of a 2GIG GoControl using the control panel: * Tap Security . * Tap Menu . * Tap Toolbox . * Enter the master code. * In the Toolbox , tap → to scroll to the next page. * Tap Version . The 2GIG GoControl'…
2GIG Image Sensors do not show the signal strength due to the radio frequency (RF) protocol used by 2GIG. However, 2GIG panels can check if the Image Sensor is connected to the network through the native Sensor Test menu. To access Sensor Test from the panel: * Tap Security . * Tap Menu . * Enter the master o…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG Go!Cont…
The 2GIG GoControl 1 and 2 panel allows users to interact with Z-Wave lights, thermostats, locks, and garage devices locally at the panel in the Services menu. Note : Additional Z-Wave devices may be able to be added and controlled locally. For more information, refer to the device manufacturer. To interact with …
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
The loud sound emitted by a 2GIG GoControl panel (or the siren sound for three seconds, if an external siren is attached) when arming is due to UL supervision settings. When the commercial UL option is selected in the customer's monitoring settings, the panel emits an audible indicator of acknowledgment when an armin…
PIR sensitivity settings By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). The sensitivity can be configured …
Sensor restorals are sent if a sensor triggers an alarm and is then closed or reset before the system is disarmed. Important : Sensor restorals are forwarded only if the sensor is closed before disarming the panel. If the panel is disarmed with the sensor open, then the sensor is closed after disarming, a restoral i…