Configure panel programming on a 2GIG GC3
Panel programming for the 2GIG GC3 can be configured locally using the panel or remotely using the Partner Portal or MobileTech app. To configure panel programming using the panel: * On the home screen, tap System Settings . * Enter the installer code. * Tap Installer Toolbox . * Tap System Configuration . …
2GIG GC3 Image Sensor Transceiver (2GIG-XCVR3-GC3) - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GC3 Ima…
What are the dialer delay settings for the 2GIG GC3?
Dialer delay settings * Default dialer delay is 30 seconds. * Minimum is 15 seconds. * Maximum is 45 seconds. Panic alarm forwarding Note : These are panel programming specific and cannot be changed. On the 2GIG GC3, the following alarms send immediately with no dialer delay: * Duress code * Silent panic *…
Connect a 2GIG GC3 to a Wi-Fi network
The panel can be connected to a Wi-Fi network by either manually selecting the network or using Wireless Protected Setup (WPS). Once the system is connected to Wi-Fi, Dual-Path communication can also be enabled. For more information about enabling Dual-Path, see Enable or disable Dual-Path communication remotely . …
2GIG GC3 - Sensor Groups
Each sensor (wireless or wired) installed in the system is programmed to a specific sensor number and sensor type (zone). The sensor number identifies the specific sensor when it is displayed on the Control Panel, recorded in the event log, or reported to the monitoring station. This allows pinpointing information…
Improve Image Sensor signal strength with a 2GIG GC3
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the GC3 panel. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting signal strength a…
2GIG GC3 - Battery Replacement
The content on this page has been written by a third party and is not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in this guide should be directed to the device manufacturer. To access the full installation guide, see 2GIG GC3 Panel - Installation Gui…
Enable Weather to Panel on a 2GIG GC3
Alarm.com offers weather to be displayed on compatible panels. The 2GIG GC3 is compatible with Weather to Panel . On the 2GIG GC3, the current day's weather displays on the home screen. There's also the option to tap Hourly or 5 Day to view more weather information. Enable Weather to Panel * To enable Weat…
2GIG GC3 Panel Version 3.2 - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GC3 Pan…
Interact with a Z-Wave device from a 2GIG GC3
he 2GIG GC3 panel allows users to interact with Z-Wave lights, locks, thermostats, and garage devices locally at the panel. For information on adding Z-Wave devices, see Manage Z-Wave devices on a 2GIG GC3 . Note : Additional Z-Wave devices may be able to be added and controlled locally. For more information, refer…
