2GIG GoControl - Sensor Restorals
Sensor restorals are sent if a sensor triggers an alarm and is then closed or reset before the system is disarmed. Important : Sensor restorals are forwarded only if the sensor is closed before disarming the panel. If the panel is disarmed with the sensor open, then the sensor is closed after disarming, a restoral i…
Adjust the Image Sensor PIR sensitivity on a 2GIG GC3
PIR sensitivity settings By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). The sensitivity can be configured t…
2GIG GC3 - Battery Replacement
The content on this page has been written by a third party and is not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in this guide should be directed to the device manufacturer. To access the full installation guide, see 2GIG GC3 Panel - Installation Gui…
2GIG GC3 - Panel-specific app feature compatibility
Some features of the Alarm.com mobile app are available or unavailable depending on panel limitations. Arming app options Silent Arming Incompatible. Silent arming can only be done locally using the panel; remote commands adhere to the local setting. No Entry Delay Compatible. Remotely Bypass Sensors …
2GIG GoControl Panic Button Remote - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer. To download this guide directly to your device, click 2GIG GoContr…
Cell module not detected displays on a 2GIG GC3
If Cell module not detected displays on a 2GIG GC3, perform the following steps to locally resolve the behavior. How to resolve: Verify compatible panel firmware Verify the panel firmware version is compatible with the module. Select Cell Radio Swap If the panel firmware version is compatible, select Cell Radi…
Adjust the Image Sensor PIR sensitivity on a 2GIG GoControl
PIR sensitivity settings By default, the Image Sensor is configured with a standard motion sensitivity profile Normal . The sensor can also be set to a more sensitive motion profile (i.e., High ) and a less sensitive profile with pet immunity for pets up to 40 lbs (i.e., Low ). The sensitivity can be configured …
Clear a severe weather alert from a 2GIG GoControl
Severe weather alerts to the panel notify customers of incoming dangerous weather. The alerts only come in for tornado, fire, or tsunami warnings. When an alert comes in, there will be a series of audible beeps and a message on the panel. For more information on severe weather alerts, see Severe Weather Alerts . N…
2GIG GC3 - Sensor Groups
Each sensor (wireless or wired) installed in the system is programmed to a specific sensor number and sensor type (zone). The sensor number identifies the specific sensor when it is displayed on the Control Panel, recorded in the event log, or reported to the monitoring station. This allows pinpointing information…
2GIG GoControl - Battery Replacement
The 2GIG GoControl requires a special battery pack available for purchase from the manufacturer. Note : The standard backup battery that is included with all 2GIG Control Panels does not support UL 985 installations. To comply with the secondary supply requirement in UL 985: Household Fire Warning System Units , in…
