Dialer delay settings for the Qolsys IQ Panel 2
Dialer delay settings depend on whether SIA limits are enabled. If SIA Limits are enabled: Default 30 seconds Minimum 15 seconds Maximum 45 seconds If SIA Limits are disabled: Default 30 seconds Minimum 0 seconds Maximum 254 seconds Configure SIA Limits To configure SIA Limits using the P…
What device IDs are Image Sensors enrolled in for a Qolsys IQ Panel 2?
Image Sensors can be enrolled in any available device ID on a Qolsys IQ Panel 2. Additional resources Enroll in the Interactive Services & Image Sensor 201 training course today! For more information on accessing Academy Training, see How can I access Academy Training? .
Interact with Garage Doors from a Qolsys IQ Panel 2
The Qolsys IQ Panel 2 allows users to interact with Z-Wave Linear and LiftMaster garage door controls locally at the panel. Important : The panel must be on firmware version 2.4.0+ to interact with LiftMaster garage door solutions. Allow up to 5 minutes for the garage section to appear locally on the screen after up…
Qolsys IQ Panel 2 Software Version 2.3.0 - Installation Guide
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Qolsys IQ Panel 2 - Compatible Sensors
The guides attached to this page have been written by a third party and are not maintained by Alarm.com. Any questions regarding the installation, maintenance, and/or usage instructions in these guides should be directed to the device manufacturer.
Improve Image Sensor signal strength with a Qolsys IQ Panel 2
The Alarm.com Image Sensor communicates over a radio frequency (RF) to the Image Sensor daughterboard. For proper operation, the Image Sensor requires a minimum of 30% signal strength. Over 40% is recommended. While there are no repeaters to increase Image Sensor RF range, there are a few steps for troubleshooting …
Qolsys IQ Panel 2 is Disarming by Itself
If the Qolsys IQ Panel 2 is disarming by itself, verify the following. Verify if Bluetooth disarming is enabled The Qolsys IQ Panel 2 has the ability to enable a Bluetooth device to disarm the system from an armed away state when it comes within range of the panel. When the system is disarmed by the Bluetooth devic…
Take a Peek-in from the Qolsys IQ Panel 2 camera
Peek-Ins allow users to take on-demand snapshots from the Qolsys IQ Panel 2 panel camera using the Customer Website and app. Captured Images are saved in the Images event gallery. For more information about viewing the event gallery, see View the Images Event Gallery and Past Events . Compatibility * The Qolsy…
Configure Face Recognition for unexpected activity on a Qolsys IQ Panel 2
Customers can monitor for unauthorized code sharing and receive alerts whenever the person using a disarm code is different from the person assigned to that code. These alerts include a disarm image taken at the panel, so customers can see who accessed their properties and take immediate action as needed. This featur…
Configure Panel Programming on a Qolsys IQ Panel 2
Panel programming for the Qolsys IQ Panel 2 can be configured locally using the panel or remotely using the Partner Portal or MobileTech app. To configure panel programming using the panel: * Flick down to open the menu, then tap Settings . * Tap Advanced Settings . * Enter the installer code or dealer code. …
