You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > True Protection > Alarm Systems > Qolsys > Qolsys IQ2 + Panel > Adjust the Image Sensor PIR sensitivity on a Qolsys IQ Panel 2
Adjust the Image Sensor PIR sensitivity on a Qolsys IQ Panel 2
print icon

Adjust PIR Sensitivity & Test Image Sensors on Qolsys IQ Panel 2

Adjust PIR Sensitivity

By default, Image Sensors are set to Normal sensitivity. You can adjust the profile via the Partner Portal or MobileTech app:

  • Normal – standard motion detection (default).
  • High – more sensitive, but may cause false alarms near heat sources or windows.
  • Low – less sensitive, with pet immunity for pets up to 40 lbs.

Tip: If sensors are mounted near windows or heat sources, use Low sensitivity to avoid false alarms.

PIR Operation & Test Mode

  • PIR can activate once every 3 minutes during normal disarmed operation.
  • After powering up, there is a 30-second delay before PIR detection is active.
  • After enrollment, the sensor enters test mode for 3 minutes: LED lights for 3 seconds per motion event (max once every 8 seconds).
  • For more testing time, re-enter test mode via the panel or by tampering the sensor.

Test PIR on Qolsys IQ Panel 2

  1. On the panel, tap Settings.
  2. Tap Advanced Settings.
  3. Enter the installer code.
  4. Tap System Tests.
  5. Tap Image Sensor Config.
  6. Tap View for the Image Sensor to test.
  7. Tap Sensor Tests.
  8. Tap Start PIR Test. A confirmation displays when test mode is active (may take up to 30 seconds).

Helpful Links

Feedback
0 out of 0 found this helpful

Attachments

Adjust_the_Image_Sensor_PIR_sensitivity_on_a_Qolsys_IQ_Panel_2.pdf
scroll to top icon