140
The following displays the trigger button for common Z-Wave devices when enrolling or removing devices from a Z-Wave network.
For device-specific information, see the guides in Installation and Troubleshooting.
For a full list of supported devices, visit Alarm.com/hardware.
Lights, Switches, and Energy Metering
|
Plug-in Module (All Brands) With the device plugged into an outlet, tap the button twice. |
In-Wall Switch (All Brands) With the switch installed and wired, click the top or bottom of the rocker twice. |
In-Wall Outlets With the device powered: Evolve: Tap button twice. GE: Tap button once. Linear: Tap button once. |
|
Smart Energy Meter With the device powered, tap the Action/Home Energy Meter button. The light will remain solid for 3 seconds. |
Smart Energy Switch With the device plugged in, tap the button once. |
Heavy Duty Smart Switch With the device powered up, tap the action button. |
|
GoControl and Qolsys IQ Lightbulbs Power the lightbulb. The light will blink. |
Thermostats
|
Alarm.com Thermostat With the device installed and powered, press MODE until the HEAT and COOL lights are off. Hold DOWN until the radio icon flashes. |
Alarm.com Remote Temperature Sensor Tap the button on the side of the sensor. |
Trane and RCS Thermostats With the device installed and powered, press MENU. Scroll to Z-WAVE INSTALL and press SELECT. Then press YES. |
|
2GIG CT-30/ GE TSTAT-300 With the device installed and powered, press MENU, then press MATE twice. The word ”link” will appear below the radio. |
2GIG CT-100 With the device installed and powered, press MENU, then press MATE twice. The word Link appears below the radio. Note: For full compatibility, the 2GIG panel must be on version 1.9 +. If a CT-100 is added to a 2GIG before upgrading the panel to 1.9 +, it is necessary to remove and re-enroll the CT100 after the upgrade in order to be fully compatible. |
Linear Thermostat With the device installed, powered, and woken up, press FAN until ”SETUP” displays in the status line. Scroll to ”Z-Wave” and press SELECT. Press SELECT again. |
Locks
|
All Kwikset Locks With the lock powered, press the A (or top left) button on the inner side of the lock once. |
Yale Keyed Locks With the lock powered, enter the master code and press #. Enter 7,#,1,#. |
Yale Key-Free Locks With the lock powered, press the button with the radio icon until the device beeps twice. |
|
Schlage BE468/469 With the lock powered and locked, press the SCHLAGE button. Enter the 6-digit programming code, followed by 0. |
Schlage FE599 With the lock powered and locked, enter the 6-digit programming code. After 3 lights and 3 beeps, press the SCHLAGE button, followed by 0. |
Other
|
Linear Garage Controller Tap the button on the side of the controller. |
The Quickbox Open the box using a supplied credential. Press the blue button on the underside of the lid. |
FortrezZ or WaterCop Water Valves Press the MODE button. |
