ADC-VC836 Turret Camera: Adjusting the Lens Angle

The Indoor/Outdoor Turret Camera (ADC-VC836) features an adjustable lens module so you can optimize the viewing angle for different mounting positions (eaves, ceilings, or walls). Follow the steps below to fine-tune your coverage and reduce blind spots.

Before You Begin

Have a small screwdriver or hex/Allen key (for the set screw).
Open the live view on the Customer Website or app to verify the new angle after adjustment.
If working on a ladder, use proper safety precautions.

Step-by-Step: Adjust the Lens Angle

If the camera is already mounted, carefully take the camera down to access the adjustment point.
Locate the set screw on the back of the camera and loosen it just enough to allow movement.
Adjust the turret lens to the desired view (pan/tilt within the housing).
Tighten the set screw to secure the angle.
Re-mount the camera and confirm framing using live video.

Positioning Tips

Avoid pointing directly into bright light sources (e.g., sunrise/sunset) to reduce glare.
Cover entry points and walkways with a slight downward angle for better subject detail.
After tightening, gently tap the housing—if the picture shifts, retighten the set screw.

Need More Help?

For additional setup guidance, visit our Support Center or review User Guide Documents. For personalized assistance, Contact True Protection. Exploring more options? See our Video Surveillance solutions.

FAQs

Do I need to fully remove the camera to adjust the angle?

No, but taking it down makes the set screw easier to access and helps you make more precise adjustments.

Will adjusting the lens affect focus?

No—this adjustment changes the direction of view, not the lens focus. If focus appears soft, clean the dome and lens window.

What if the camera view drifts after I re-mount it?

Ensure the set screw is tight and the mounting bracket is secure. Re-check live view after tightening.