255
| LED pattern | Status | Description |
|---|---|---|
 |
Connected to the internet | Local network and internet connection with Alarm.com IP. |
 |
Local network connection |
Local network connection with local IP address, no internet. Note: If the LED does not go solid green after a few minutes, see Camera LED is blinking green. |
 |
Power on, or no network connection |
Power on, system booting up typically 60-90 seconds. If solid red for longer than 60-90 seconds, then there is no local or Internet connection. |
 |
Camera powering on, or firmware update | Camera is powering on, or a firmware update is in progress. |
 |
WPS mode |
WPS mode is active. To enter WPS mode, press and hold the WPS button for about 3 seconds. |
 |
AP mode |
Wi-Fi access point (AP) mode is active. To enter AP mode, press and hold the WPS button for about 6 seconds. |
 |
Factory reset |
The camera is restoring to factory default settings. Caution: If the camera is already installed, it may need to be removed from the Alarm.com account and re-added after a factory reset. To perform a factory reset, press and hold the reset button for about 10-15 seconds. |
Note: The WPS and reset options share the same button on the ADC-522IR.
