207
Crystal-clear 1080p HD video, infrared night vision and secure cloud recording make the ADC-V522IR Wi-Fi Video Camera from Alarm.com ideal for indoor video monitoring. With its compact design and flexible mounting options, the ADC-V522IR is easy to install – whether mounted on a wall or ceiling or simply placed on a shelf.
Features
- HD 1080p video
- IR night vision
- Wide dynamic range (WDR)
- Two-Way Audio (see Two-Way Audio Compatibility FAQ)
- Video Analytics, Video Motion Detection, and sensor-triggered clips saved to the cloud
Included accessories
- Wi-Fi Video camera
- Camera stand
- Quick Installation Guide
- Mounting hardware
- Power adapter (10 feet)
Specifications
|
Maximum resolution |
1920x1080 |
|---|---|
|
Recording compression |
H.264, MPEG-4 |
|
Image sensor |
1/2.9" CMOS, 2.12 MP, 1920x1080 |
|
Lens |
2.8 mm, F1.85 |
|
Angle of view |
113° |
|
Low-light sensitivity |
0 lux with IR |
|
IR range |
Up to 5 meters (~15 feet) |
|
Image adjustments |
Flip, brightness, contrast, saturation, sharpness |
|
Video motion detection |
3 windows, adjustable sensitivity and threshold |
|
Wireless connectivity |
802.11 b/g/n/ac, 2.4 & 5 GHz |
|
Ethernet connection |
10/100Mbps RJ-45 |
|
Simultaneous viewers |
10 |
|
Operating temperature |
0°C – 40°C (32°F – 104°F) |
|
Operating humidity |
20%-80% (non-condensing) RH |
|
Max power consumption |
12 V DC, 5 W |
|
Dimensions (WxH) |
2.75” x 2.06” x 3.67” |
| Two-Way Audio compatibility | Hardware Version 0101 and Firmware Version IP8168-ALAM-0100b9 + |
Note: For information about frame rate (FPS), see What is the frame rate for video?.
Network requirements
| Minimum bandwidth |
Without Two-Way Audio: 0.5 Mbps With Two-Way Audio: 1 Mbps For more information, see What are the internet service and bandwidth requirements for Alarm.com video devices?. |
|---|
LED Guide
| LED pattern | Status | Description |
|---|---|---|
 |
Connected to the internet | Local network and internet connection with Alarm.com IP. |
 |
Local network connection |
Local network connection with local IP address, no internet. Note: If the LED does not go solid green after a few minutes, see Camera LED is blinking green. |
 |
Power on, or no network connection |
Power on, system booting up typically 60-90 seconds. If solid red for longer than 60-90 seconds, then there is no local or Internet connection. |
 |
Camera powering on, or firmware update | Camera is powering on, or a firmware update is in progress. |
 |
WPS mode |
WPS mode is active. To enter WPS mode, press and hold the WPS button for about 3 seconds. |
 |
AP mode |
Wi-Fi access point (AP) mode is active. To enter AP mode, press and hold the WPS button for about 6 seconds. |
 |
Factory reset |
The camera is restoring to factory default settings. Caution: If the camera is already installed, it may need to be removed from the Alarm.com account and re-added after a factory reset. To perform a factory reset, press and hold the reset button for about 10-15 seconds. |
Note: The WPS and reset options share the same button on the ADC-522IR.
