ADC-V723: Install an SD Card & Enable Onboard Recording (Smart View)
The ADC-V723 supports Onboard Recording with Smart View, allowing the camera to record continuously to a microSD card without any additional hardware. Follow the steps below to install the card and create a local recording schedule.
Before You Start
- Have a compatible microSD card ready (insert it before mounting to avoid drops).
- Access to the camera’s underside (near the QR code and MAC address).
- Customer Website login for creating the local recording schedule.
Install a microSD Card in the ADC-V723
- Uninstall if needed: If the camera is already mounted, remove it to better access the SD slot.
- Open the door: Unscrew the two screws on either side of the small door on the bottom face.
- Lift & rotate: Gently lift and rotate the door to clear the slot. Avoid pulling hard on the door.
- Insert the card: Push the microSD card into the slot until it clicks.
- Close up: Rotate the door back and firmly replace the two screws.
Enable Onboard Recording (Customer Website)
- Verify the microSD card is inserted into the camera.
- Log into the Customer Website.
- Go to Video → Recording Rules → Local Recordings.
- Click + Add New Schedule.
- In Select a camera to record from, choose the ADC-V723.
- Use the Select recording quality slider to choose the desired quality.
- Under Schedule recording time, choose:
- At all times (continuous), or
- Only during the following times (set specific days/hours).
- (Optional) Limit days kept: Toggle Limit the number of days to record, then select the max days to retain.
- Click Save to finish.
Tips & Best Practices
- Insert/remove the microSD card only when the camera is powered down to prevent corruption.
- If you change the schedule or quality, allow a few minutes for settings to apply.
- Periodically review storage limits so important footage isn’t overwritten too quickly.
Need More Help?
See our Support Center and User Guide Documents for camera setup tips, or Video Surveillance to explore compatible solutions. For one-on-one help, Contact True Protection.
FAQs
Can the ADC-V723 record without an SVR?
Yes. Onboard Recording uses a microSD card inside the camera—no SVR is required.
What if the card isn’t recognized?
Power the camera down, reseat the card until it clicks, then power back up and recheck Local Recordings.
Will old footage be overwritten?
Yes. When storage fills, the oldest clips are overwritten. Use the “Limit the number of days to record” option to manage retention.