Schlage Z-Wave Deadbolt (BE369) [Legacy] - Battery Replacement
Jun 04, 2021
148
The content on this page has been written by a third party and is not maintained by Alarm.com.
Any questions regarding the installation, maintenance, and/or usage instructions in this guide should be directed to the device manufacturer.
To access the full user guide, see Schlage Z-Wave Deadbolt (BE369) [Legacy] - User Guide.
The Schlage Z-Wave Deadbolt (BE369) requires three AA batteries and one 9V battery.
To replace the batteries in a Schlage Z-Wave Deadbolt (BE369):
- Remove cover screws.
- Remove the upper left screw to release the upper battery tray. Hold the battery tray in place while loosening the screw.
- The upper battery tray will be released. Fully remove the tray and remove the three old AA batteries.
- Remove the 9V battery.
- Remove the 9V connector from the old 9V battery.
- Replace all batteries with new, high-quality batteries. Reverse steps to replace the battery tray and cover. Be careful not to pinch wires when replacing the cover.
Note: If the low battery does not automatically clear on the customer's equipment list, request an updated status from the lock using the Partner Portal or MobileTech app. For more information about requesting the status, see Request an updated status on Z-Wave devices.
