How to Enroll or Delete a Kwikset 910 Z-Wave Deadbolt

Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to enroll and communicate. Each extra command introduces more opportunities for a communication breakdown, so proper installation is critical.

Important Note

Do not add or delete user codes locally on the lock. 

Enroll a Kwikset 910 Deadbolt into a Z-Wave Network

1. Begin with the lock within six feet of the panel or module.
2. Place the panel into Add Mode.
3. Press the white button to the left of the SmartCode logo (inside the cover on the interior panel).
4. Wait two minutes before locally operating the device.
5. Verify that the lock appears on the Alarm.com website and responds to lock/unlock commands.
6. Move the lock to its final location and run a Network Rediscovery using the Partner Portal or MobileTech app.

Delete a Kwikset 910 Deadbolt from a Z-Wave Network

1. Place the panel into Delete Mode.
2. Press the white button to the left of the SmartCode logo (inside the cover on the interior panel).
3. Run a Network Rediscovery on the Partner Portal or MobileTech app.

Additional Resources

• Smart Lock Installation
• Smart Home Automation
• Contact True Protection Support