You are using an unsupported browser. Please update your browser to the latest version on or before July 31, 2020.
close
You are viewing the article in preview mode. It is not live at the moment.
Home > True Protection > CCTV Systems > Alarm.com Cameras > Alarm.com Cameras > Indoor/Outdoor Mini Bullet (ADC-VC725) - Installation Guide
Indoor/Outdoor Mini Bullet (ADC-VC725) - Installation Guide
print icon

How to Install and Connect the ADC-VC725 Mini Bullet Camera

The ADC-VC725 Mini Bullet Camera from Alarm.com is a compact, high-performance security camera designed for both residential and commercial installations. With its IP66-rated dust-resistant housing and Power-over-Ethernet (PoE) capabilities, it delivers reliable HD video monitoring indoors and outdoors.

Pre-Setup Checklist

  • ADC-VC725 camera (included)
  • AC power adapter (required for non-PoE connections)
  • Broadband Internet (Cable, DSL, or Fiber Optic) with router
  • Computer or mobile device with Internet access
  • Ethernet/Cat5 cable
  • Alarm.com account login and password

For a full list of specifications, see the ADC-VC725 Mini Bullet Camera Data Sheet.

Adding the Camera to an Alarm.com Account

Before mounting, connect the camera and enroll it to the Alarm.com account:

  1. Connect the camera to the router via an Ethernet cable.
    For details on PoE connections, see PoE setup guide.
  2. If Ethernet does not supply power, connect the camera to an AC power adapter and plug it into a non-switched outlet.
  3. Wait at least two minutes for the camera to establish an Internet connection.
  4. Add the device to the Alarm.com account using one of the following methods:
    • MobileTech app
    • Customer app Video Installation Wizard
  5. Follow the on-screen prompts to complete setup.
  6. Once enrolled, power down the camera and install it permanently using the included mounting hardware.

Troubleshooting

If the ADC-VC725 does not connect properly:

  • Power cycle the camera by unplugging and reconnecting it.
  • If issues persist, reset the camera to factory defaults:

Factory Reset Instructions

  1. Disconnect the camera from the power source.
  2. Unscrew and remove the camera cover carefully to avoid damaging the wires.
  3. Locate the Reset button under the cover.
  4. Press and hold the Reset button while reconnecting power.
  5. Continue holding the button for 10 seconds, then release.

After a reset, it is recommended to leave the camera powered on and undisturbed for at least two minutes.

Need More Help?

Visit the Alarm.com Support Center or reach out to True Protection Support for additional installation assistance.

Feedback
0 out of 0 found this helpful

Attachments

Indoor_Outdoor_Mini_Bullet_ADC-VC725_-_Installation_Guide.pdf
scroll to top icon