ADC-VDB770 Video Doorbell: Installation Overview & LED Guide

The ADC-VDB770 is Alarm.com’s advanced video doorbell with two-way audio, video analytics, and wide-angle coverage. This overview provides the essential installation flow, post-installation checks, and a quick-reference LED status guide.

For complete instructions, see the ADC-VDB770 Installation Guide and Enrollment Best Practices.

Pre-Installation Checklist

Run a speed test (minimum 2.5 Mbps upload speed required)
Test existing chime for proper functionality
Verify voltage and power (16–30V AC, 10 VA)
Turn off electricity to the transformer

Installation Steps

Install the power module
Install the mounting bracket and backplate
Attach the video doorbell
Turn electricity back on to the transformer
Connect the doorbell to the Wi-Fi network
Enroll the doorbell to the customer’s Alarm.com account

Post-Installation Setup

Test live video stream and Two-Way Audio
Configure chime type and verify chime functionality
Select and confirm the mounting bracket (wedge type)
Test interaction with other devices from the call screen
Create and test:
- Doorbell Call recording rule
- Doorbell Call notification
- Video Analytics recording rule + notifications

ADC-VDB770 LED Status Guide

LED Pattern	Description
Off	Power off
Solid red	No local or Internet connection
Blinking red	Power on, camera booting
Solid green	Connected to Alarm.com
Blinking green	Local network connection
Double-blinking blue	Unable to ring indoor chime (learn more)
Blinking blue	WPS mode (press & hold 30–45s)
Blinking white	Wi-Fi Access Point mode (press & hold 45–60s)
Blinking yellow	Camera power cycling (press & hold 60–75s)
Alternating red & green	Factory reset (press & hold >75s)

Note: If the indoor chime is enabled, pressing the button triggers a chime. To avoid this, disable the chime in the Customer Website before initiating any LED modes.

Need More Help?

For detailed setup, visit the Support Center or explore our Video Doorbell Camera solutions.